[Simnibs-discuss] Generating individual tissue STL from MSH file

[Oula Puonti]

Hi Yuchao,

See example here:

https://github.com/simnibs/simnibs/issues/111

Best,
Oula


On Mon, 2023-01-30 at 22:33 +0000, Wang, Yuchao wrote:
> Hello SimNIBS team, 
>  
> It seems like charm in 4.0 no longer automatically generates
> individual tissue .stl files and I'm having trouble extracting them
> from the .msh file. I couldn't locate any commands (e.g. here) that
> exports .stl based on the physical surfaces in .msh.opt. Could you
> provide some help?
> 
> Thanks a lot and thank you for this great program!
> 
> Yuchao
>  
>  
> The information in this e-mail is intended only for the person to
> whom it is addressed.  If you believe this e-mail was sent to you in
> error and the e-mail contains patient information, please contact the
> Mass General Brigham Compliance HelpLine at
> https://www.massgeneralbrigham.org/complianceline .
> 
> Please note that this e-mail is not secure (encrypted).  If you do
> not wish to continue communication over unencrypted e-mail, please
> notify the sender of this message immediately.  Continuing to send or
> respond to e-mail after receiving this message means you understand
> and accept this risk and wish to continue to communicate over
> unencrypted e-mail.  
> _______________________________________________
> Simnibs-discuss mailing list
> Simnibs-discuss at drcmr.dk
> https://mailman.drcmr.dk/mailman/listinfo/simnibs-discuss